|
IAG Series (Rocker)
Low-cost, Airpax™ magnetic circuit breaker that combines power switching and accurate, reliable circuit protection for equipment in the international market place. Rocker handle configuration.
Product family: 217
|
|
|
IAG Series (Rocker)
A: It is recommended that power leads be soldered to circuit breakers having push-on type terminals for current trip ratings above 20 amperes.
B: When "A" (metric thread mounting) is specified in the sixth decision in combination with screw terminal option in the second decision, metric screw terminals are supplied.
C: IEGX and IEGZX circuit breakers are designed to meet 8mm creepage and clearance requirements for installation Category III, Pollution Degree 3, Case A as measured in IEC 664. Intended for use in equipment designed to comply with IEC 601 and 950 and VDE 0804 and 0805.
D: For Type IUGX, IUGZX and IUGBX Rocker Handle UL 1077 Recognized, CSA Certified Ratings.
E: For Type IEGX, IEGZX and , IEGBX Rocker Handle UL 1077 Recognized, CSA Certified Ratings, VDE Approved (see Note C).
F: For Type CUGX, CUGZX and CUGBX Rocker Handle UL 489A listed, CSA Certified Ratings.
G: For Type CEGX, CEGZX and CEGBX Rocker Handle UL 489A Listed, CSA Certified Ratings, VDE Approved (see Note C).
H: For Series with auxiliary switch, only one auxiliary switch is normally supplied on two and three pole units. Switch is located in the right-hand pole (viewed from terminal end) unless otherwise specified.
I: For Rated Current standard ratings listed. For other ratings, please contact the factory.
J: For Mounting one or more descriptions may be used as required.
K: For "A" Mounting table 7 may be substituted and U.S. thread will be supplied. Unit will be rated at 250V (50/60Hz only).
L: For "X" Mounting Consult factory for availability.
M: Terminal protusion dimensions are referenced from back of mounting panel.
N: Main Terminals are male push-on types .250 (6.35) wide x .031 (.79) thick x .375 (9.53) long or 8-32 x .187 (4.75) screw type. Metric screw terminals are m4x5mm. On VDE approved builds with screw terminals, external tooth lock washers are supplied. On VDE approved builds with push-on terminals a soldered connection is required above 25 amperes.
O: Switch only - No current overload protection provided.
P: Rocker Handle Marking Color is white on black and red handles, and black on white, orange and grey handles.
Q: Bezel of ZX and BX is black.
|
IAG Series (Rocker)
Images related to selected product options on Assemble tab.
|
|
|