A: It is recommended that power leads be soldered to circuit breakers having push-on type terminals for current trip ratings above 20 amperes.
B: When "A" (metric thread mounting) is specified in the sixth decision in combination with screw terminal option in the second decision, metric screw terminals are supplied.
C: IEG, IEGH, IEGS and IEGHS circuit breakers are designed to meet 8mm creepage and clearance requirements for installation Category III, Pollution Degree 3, Case A as measured in IEC 664. Intended for use in equipment designed to comply with IEC 601 and 950 and VDE 0804 and 0805.
D: For Type IUG, IUGH, IUGN, IUGS and IUGHS Toggle Handle UL 1077 Recognized, CSA Certified Ratings.
E: For Type IEG, IEGH, IEGS, IEGHS, IMG and IMGH Toggle Handle UL 1077 Recognized, CSA Certified Ratings, VDE Approved (see Note C).
F: For Type IDG and IDGH Toggle Handle UL 1077 Recognized, UL 1500.
G: For Type CUG, CUGH, CUGS, CUGHS, CMG and CMGH Toggle Handle UL 489A listed, CSA Certified Ratings.
H: For Type CEG, CEGH, CEGS and CEGHS Toggle Handle UL 489A Listed, CSA Certified Ratings, VDE Approved (see Note C).
I: For Series with auxiliary switch, only one auxiliary switch is normally supplied on two and three pole units. Switch is located in the right-hand pole (viewed from terminal end) unless otherwise specified.
J: For Rated Current standard ratings listed. For other ratings, please contact the factory.
K: For Mounting one or more descriptions may be used as required.
L: For "A" Mounting table 7 may be substituted and U.S. thread will be supplied. Unit will be rated at 250V (50/60Hz only).
M: For Mounting IEGS standard face plate is bevelled.
N: For "X" Mounting Consult factory for availability.
O: For Marked Toggle Handles IAG, IUG, IEG, IAGH, IUGH, IEGH, IEGS and IEGHS handle marking color is white on black, red, blue & green handles and black on white, yellow, grey & and orange handles.
P: Terminal protusion dimensions are referenced from back of mounting panel.
Q: Main Terminals are male push-on types .250 (6.35) wide x .031 (.79) thick x .375 (9.53) long or 8-32 x .187 (4.75) screw type. Metric screw terminals are m4x5mm. On VDE approved builds with screw terminals, external tooth lock washers are supplied. On VDE approved builds with push-on terminals a soldered connection is required above 25 amperes.
R: Switch only - No current overload protection provided.