|
|
|
|
SNAPAK® (Rocker Handle)
You are building an Airpax™ hydraulic-magnetic circuit breaker (SNAPAK®) with a rocker handle configuration.
Product family: 213
|
|
|
SNAPAK® (Rocker Handle)
A: A neon bulb is provided when specified for 120Vac and 250Vac operation. For operation at 120Vac a 33,000 ohm, 1/2 watt external resistor is required. At 250Vac a 100,000 ohm, 1 watt external resistor is required.
B: An LED with 750 ft. L @ 20mA is provided in the center of the handle. Maximum power dissipation @ 25 degrees C is 180mW. Continuous forward current is 40mA. Forward voltage, typical, is 1.6v at 20mA. Reverse current, typical, is 100mA @ 3.0 volts. An external resistor may be required to limit current to these values.
C: When ordering Paddle Handles, you may choose one item from each hardware group to add to 5th decision if such items are desired. For example, "-11ALS" would indicate a bright nickel knurled nut, plus a vertical mount indicator, plus a locking ring, plus #6-32 screw terminal adapters. For Push-Pull, Rocker and Push-to-Reset versions, you may add only the #6-32 screw terminal adapters (-S).
D: All units except Rocker units will have (1) hex nut installed as standard hardware for the back of a panel. The choices in the fifth decision table are intended for the front or visible side of the panel and are offered for Paddle Handle configuration only. Push-Pull and Push-to-Reset configurations include one (1) panel nut and one (1) hex nut as standard hardware.
E: For Mixed Construction consult Factory or sales representative for part number.
F: Switch only - No current overload protection provided.
|
SNAPAK® (Rocker Handle)
Images related to selected product options on Assemble tab.
|
|
|